IRS + Straight Axle Handbrake Cable Spacers

Spacers required when installing an IRS or Swing Axle Conversion onto a Splitscreen Bus to take up the slack of the conduit on the handbrake cable to the backing plates.

These tubes fit on the conduit closest to the front of the van where the cable/conduit enters the chassis.

The return spring on each cable needs to be cut down by roughly the same length of the spacer. 

You may need to take a little material off the threaded section on the cable itself if it does not fit through the tube extender.

This allows you to install 1964 to 1967 Splitscreen Bus handbrake cables.

Sold in Pairs