Karmann Ghia Rear Axles and Driveshafts

Tough Hi-Performance Sway-A-Way Racing Axle Same dimensions as 1961 – 1966 Beetle They start with superior steel, and heat treating. The axles are...

Tough Hi-Performance Sway-A-Way Racing axles Fit 1968 Beetles and all Type 3 models They start with superior steel, and heat treating. The...

Uprate chromoly race axles for used to replace the standard CV Joint shafts on the rear of all VW Beetles with IRS rear suspension.

Complete drive shaft to fit 1302 + 1303 Beetles and Karmann Ghias with IRS suspension

It will fit all 1302 and 1303 Beetles plus any Splitscreen Buses using the IRS rear axle set up off...

This top quality reproduction product has been manufacturered by CSP in Germany. It will fit all 1302 and 1303 Beetles plus...

Do you want to install the much stronger Bus CV Joints onto your IRS Beetle or Karmann Ghia?

If so then these modified rear stub axles are a must.

Swing Axle Gearbox Tube With Boot,Flange + Bearing Housing Left T1 1968-79 (Long axle)

Swing Axle Gearbox Tube With Boot,Flange + Bearing Housing Right T1 1968-79 (Long axle)

This gasket is 0.008" thick (0.20mm) and is used to help get the right spacing on the rear axle tubes on all Swing axle gearboxes.